Resources
An anchor bolt is a threaded item used to attach embed plates into concrete on structural supports.
Anchor Bolts with Polyethylene Sleeves
Pipe spool is a section of pipe that comes in pre-fabricated lengths from the pipe fabricator.
See the following article for FRP Wear Pad Installation: www.pipingtech.com/technical/im/frp-pad.htm
Usually it would show a disparity between stresses at a particularpoint. For example, a carbon steel element joined to a stainless steel elementwould show significantly different stresses over the same temperature change.
Embedplates are metal components which are essentially set-in foundation elementssuch as concrete floors, piers, etc. They provide an attachment point forwelding support components in position or for the addition of sliding plateelements to permit movement along the surface of the embed plates.
Embed Plates
A pig receiver is a device that “catches” the cleaning device (“pig”) after it has passed through the pipeline.
Pig Receiver with a 24″ Dia. Minor Barrel
A pig launcher is a device which uses a pressurized container to shoot a cleaning device (“pig”) through the pipeline to perform a variety of functions including cleaning, monitoring, and maintaining of the pipe.
Pig Launcher and Receiver
Pig launchers are required whenever specifications call for routine cleaning or monitoring of the interior pipe surface.
Normally valves are used to control flow in pipe line. The main two reasons for using spectacle blinds are when there is a space restriction and valves cannot be installed, and also spectacle blinds are much more economical than valves.
A spool duct simply refers to a section of the pipe that is used totransfer gases in lieu of liquids.
Engine Exhaust Spool Duct
A bellmouth reducer is a single piece component used whenever pipes transition from a large outside diameter to a smaller outside diameter.
Bellmouth Reducer
The specific temperature at which personnel protection equipment isrequired would be site specific. The average temperature where protectivemeasures would be incorporated would be about + 200 degrees Fahrenheit.
Cable mounts, also known as Primary Support Modules (Instrument Supports), utilize adjustable, high-strength cables to clamp instrument assemblies to process lines 3″ through 36″ in diameter. These Primary Modules can be used independently or together with Secondary Modules to construct a universal support package for any instrument in any position.
