Constant Spring Support Assemblies Designed for a Chemical Plant in New Jersey

January 23, 2017

Constant Spring Support Assemblies Designed for a Chemical Plant in New Jersey

Type: Constant Spring Supports
Size: PTP 200 C-Type Double Suspension
Material: Hot-dipped Galvanized Carbon Steel | Epoxy Coated Springs
Load: 8,000 lb. – 19,000 lb. | Upward Movement: 6″ – 9″
Testing: Standard Load and Travel Test

PT&P designed twelve constant spring support assemblies for a chemical plant in New Jersey. The assemblies will be used as replacements in a recuperator up-leg and down-leg application in conjunction with custom cross-over supports previously fabricated by PT&P. Physical sizes of these constant assemblies range from 18-1/2″ x 22″ x 64″ to 18-1/2″ x 26″ x 83″. Operating loads range between 8,000 lb. – 19,000 lb. and each allows for upward movement between 6″ – 9″. The spring coils are coated with epoxy instead of the standard neoprene coating. Standard load and travel tests were completed prior to shipment.

Read More

Variable Spring Hangers Designed for an Ammonia Plant

January 9, 2017

Variable Spring Hangers Designed for an Ammonia Plant

Type: B-Type Variable Spring Hanger
Size: PTP-2 Standard Variable Spring
Material: Hot-dipped Galvanized Carbon Steel
Design: 0.955″ Downward Movement | Cold Load: 12,183 lb. | Hot Load: 14,723 lb.
Testing: Hydro-load Test: 15,750 lb.

PT&P designed and fabricated variable spring hangers for an Ammonia Plant in Louisiana. This B-Type PTP-2 variable hanger is fabricated from carbon steel and hot-dipped galvanized to protect against corrosion. The variable is designed for 0.955″ of downward movement and an installed load of 12,183 and an operating load of 14,723 lb. This variable included a 1″ forged steel clevis and the assembly was tested at a hydro-load of 15,750 lb.

Read More
Top