Graphite Slide Plates for an Technology and Engineering Company in North Carolina

July 29, 2019

 

 

Graphite Slide Plates for an Technology and Engineering Company in North Carolina

Type: Graphite Slide Plates
Size: 4”-10” Length | 4”-10″ Width
Material: Graphite Sheets | Carbon Steel
Design: 2000 PSI Operating Pressure

PT&P manufactured multiple slide bearing plates for a technology and engineering company in North Carolina. The materials for these slide plates are made of graphite sheets with carbon steel backing pads. The dimensions range in length 4”-10” and width 4”-10” with operating pressure of 2000 PSI. All carbon steel plates will be galvanized. The graphite pad will then be bonded to carbon steel backing plates with a ¾ lip.

F-Type Variable Spring Supports with Graphite Slide Plates Designed for an Oil Refinery

September 24, 2018

F-Type Variable Spring Supports with Graphite Slide Plates Designed for an Oil Refinery

Type: Variable Spring Supports with Graphite Slide Plates
Materials: CS | HDG | High Heat Aluminum Finish | Graphite
Load Range: 420 lb. to 7650 lb. | 0.65″ Upward Movement
Design: 700°F Temperature | Q.C. & Load Tests

PT&P custom designed an F-type variable spring supports with graphite slide plates for an oil refinery in California. Each assembly is equipped with round base plates (instead of the standard square plates), and are designed for temperatures up to 700°F. The spring cans are designed for a load range from 420 lb. to 7,650 lb. and movements up to 0.65” up. They are finished with high heat aluminum due to the temperature requirements. O.C. inspections and load tests were conducted prior to shipment.

Pipe Support Engineering & Design

November 27, 2017

** Turn up your speakers to hear the audio. Please be patient as the screen will become visible
shortly after the speaker begins the presentation. You may click the monitor icon below each
video to view the webinar in full-screen mode.

NOTE: PDH credits are NOT offered for our recorded webinars.

View the Slides for Above Webinar Here

PTFE Slide Plate Inspection and Maintenance

October 9, 2017

Follow these steps when inspecting and maintaining PTFE slide plates.

1. Inspect welds between backing plate and bottom of the saddle
2. Inspect adhesion of the PTFE slide plate
3. Inspect welds of the base plate of the bottom slide plate between the structural steel
4. Make sure you have a clean surface between the upper and lower slide plates

Slide Plates & Pipe Rollers in the Fight Against Friction

** Turn up your speakers to hear the audio. Please be patient as the screen will become visible
shortly after the speaker begins the presentation. You may click the monitor icon below each
video to view the webinar in full-screen mode.

NOTE: PDH credits are NOT offered for our recorded webinars.

View the Slides for Above Webinar Here

Variable Spring & Graphite Slide Plate Assemblies Custom Designed for Gasoline Production in Dubai

September 21, 2013

Variable Spring & Graphite Slide Plate Assemblies Custom Designed for Gasoline Production in Dubai
In eight weeks, PT&P provided a gasoline production plant in Dubai with two custom designed variable assemblies. Each assembly includes load columns, four variable spring cans, four channels, 12 plates, nine graphite slide plates and a custom designed frame. The frame allows the variable springs to work in unison to support large pipe trunnions. The top plates measure 45″ in width and 25″ in height. The variables are designed for an operating temperature of 750°F and an operating load of 3,150 lb. The assemblies are capable of 1/8″ upward movement and 1/6″ downward movement. A load test was conducted prior to shipment.




Top