Piping Technology & Products recently designed and manufactured three hydraulic snubbers for a construction site in Louisiana.

These snubbers, with an operating load of 3500 lbs., are 2.5 x 6 and allow for 4 of total travel distance. The lock-up velocity test was performed on these snubbers to make sure that at high rates of loading, especially impact, the snubber would provide very high resistance to movement. And, the drag test was performed to make sure that at low speeds they provide very low resistance to movement.

Do you see a need for hydraulic snubbers in your plant? Let us price them for you today!

The photograph above shows hydraulic snubbers which are used to protect critical components in refineries, power plants and other industrial systems from sudden movement by the attached piping system. Engineers specify these devices for systems which are subject to sudden accelerations caused by earthquakes, extreme wind loads or water hammer. The insert at the upper left shows eight snubbers, some are different sizes and six have dust covers to protect the piston seal. The snubber at the bottom has hardware attached so it is ready to be installed. Hydraulic snubbers resist sudden rapid movement of the pipe by limiting the flow rate of the fluid inside the snubber. The device is designed so slow movement, such as would be expected during thermal expansion, has practically no resistance, but sudden rapid movement is resisted with a force proportional to the velocity raised to a power, where the power is determined by the orifice valve and flow pattern in the design. Selection of materials and liquids used will depend on the environment where the snubber is installed.

Want to learn more about hydraulic snubbers? Visit our webinar archives!