Stanchions and Beams for a Power Center

October 18, 2002
Stanchions and Beams for a Power Center
Stanchions and Beams for a Power Center

Piping Technology & Products, Inc. designed and manufactured carbon steel and alloy stanchions for a power center in Arizona.  PT&P also produced carbon steel beams for the project.

These stanchions are made to fit Extra Strong and Standard pipes, which are 3-12 in size. Figure 1 shows the stanchions and beams for this job before they were coated with a green primer and prepared for shipment.

Do you see a need for stanchions and beams in your power plant or refinery? Get pricing today!

request-a-quote

Stainless Steel Stanchions for a Power Company

February 1, 2002
Stainless Steel Stanchions for a Power Company
Stainless Steel Stanchions for a Power Company

Piping Technology & Products, Inc. provided 35 stainless steel stanchions for pipe sizes 4 to 18 inches for a power company in Alabama.

The ends of the stanchions have shop-cut end connections that will allow field welding without any modifications by site personnel. Some stanchions were provided with straight pipe connections and others were provided with elbow connections. The minimum height requirement provided for a centerline height equal to approximately 16″ while the maximum pipe centerline was required to be at approximately 58 ½”. The stanchions were designed at 1100°F and sustained a maximum design load of 18,000 pounds. The stanchion base plates are 304 stainless steel and the tubes are constructed of A240 GR.304 seamless pipe.

Do you need stanchions for your company? Request a quote and get a response within 48 hours!

request-a-quote

Top