– Diameter: 48″ O.D.
– Capacity: 1,100 Gallons
– Material Fabricated From: Carbon Steel
– Design Temperature & Pressure: 285 PSIG at 100ºF
– Testing: Hydro-Tested and held for 1/2 hour at 428 PSIG
This pressure vessel measures 84″ in length and is fabricated entirely of SA516-70 carbon steel. It is designed for low temperature environments and has a design pressure of 117 PSIG at 500ºF. A hydrostatic test was completed at 205 PSIG prior to shipment.Read More
The duct work has an outside diameter of 90 inches and is 38 feet long. The duct assembly is fabricated entirely from ASTM A516-70 carbon steel. The assembly has two support bases and stiffening rings that provide strength and rigidity for the duct work. The assembly is a section of air supply duct in an Ammonia Plant.Read More
58″ Floating Rings for a Process Plant
– Sizes Range from 19″ I.D. to 91 1/2″ I.D.
– ASTM A-240 Grade 316H Stainless Steel
– 100% Dye Penetrant Tested on all Weld SeamsRead More
SWECO Fab, Inc. designed and fabricated this transition piece for an ammonia plant in Egypt. The bottom rectangular flange measures 159″ long and 60″ wide. The top duct assembly has an outside diameter of 90″. The entire assembly measures 48″ high. The transition piece is fabricated from ASTM A516-70 carbon steel. It is used to connect a circular duct to a rectangular duct.Read More
26″ Hot Water Expansion Tank
– Material: .25″ Thick Carbon Steel
– Design Pressure: 50 PSIG
– Design Temperature: 200 F
– Capacity: 170 Gallons
Do you require a vessel or tank for your current or upcoming job? Get pricing today!
SWECO Fab, Inc. manufactured a pig launcher and receiver used to launch a pig throughout the piping system to clean the pipe line. Both the pig launcher and receiver have been hydro-tested to ensure quality and performance. Multiple coats of paint were also applied for environment protection.Read More
Lateral joints are machined from a forged piece of stainless steel, and are used as flow diversion on pipe lines for the chemical process industry.
Pressure = 960 PSIG
Test Pressure = 1440 PSIG
Temperature = 302ºF
1 1/2′ x 3/4′
3′ x 2′
4′ x 3′
The personnel protection shields are used when insulating the line is not necessary, but operating temperatures require safeguarding personnel from coming into contact with the pipe. These shields are designed for 8″ pipe operating at 800°F, and are made of 304 stainless expanded steel rolled to a 20″ diameter.Read More
Piping Technology and Products, Inc. and SWECO Fab, Inc. designed and fabricated 24″ 300 # (ANSI rating), 2 1/2″ thick and 42″ 600 # (ANSI rating), 3 7/8″ thick carbon steel spectacle blinds. Spectacle blinds serve the same purpose as flow control valves at less the cost. Spectacle blinds either stop or continue the flow depending on which end is being utilized. PT&P/SWECO Fab. can supply these spectacle blinds in any material needed, such as stainless steel, Monel, Inconel and carbon steel. Smooth, mill, machined or serrated finish is also available upon request. PT&P/SWECO Fab. can produce this product in small quantities/sizes in 48 hours if needed.
Want to learn more about spectacle blinds? Instantly view a Sweco Fab webinar now!Read More