Structural Support Units for a Power Plant in California

June 24, 2005
Structural Support Units For A Power Plant In California
Structural Support Units for a Power Plant in California

Piping Technology and Products, Inc. recently designed and fabricated two structural support units for a power plant in California.

The structural supports pipes are made of A106 Gr. B; the beam, angle and plate are made of carbon steel. They have an overall height of 11 feet with a weight of 672 lbs. The purpose of these products is to support a 3 inch intermediate pipe.

Do you see a need for structural supports in your current job? Get pricing today!
Request-A-Quote


Read More

Pipe Shoes for an Energy Plant in Canada

June 17, 2005

 

Pipe Shoes For An Energy Plant In Canada
Pipe Shoes for an Energy Plant in Canada
Pipe Shoes For An Energy Plant In Canada
Isometric View of Shoes

Piping Technology & Products, Inc. recently designed and manufactured 566 pipe shoes for an energy plant in Canada.

These fabricated pipe shoes are manufactured to support pipes. The pipe shoes are fabricated out of A36 carbon steel with sizes ranging from 12 to 36. They have an overall weight of 134,000 lbs.

Do you require pipe shoes like those described above? Let us price them for you now!
Request-A-Quote


Read More

68 Sliding Cold Shoes with Lateral Restraint

June 10, 2005
68 Sliding Cold Shoes With Lateral Restraint
68 Sliding Cold Shoes with Lateral Restraint

Piping Technology and Products, Inc. recently fabricated and designed several sliding cold shoes with lateral restraint for a river site in Georgia. The sliding cold shoes have a frame of A36 carbon steel. These were designed to support pipes of 14 to 36 in diameter, insulated with 4.5 to 5 in thick layers of polyurethane foam.

Want to learn more about cold shoes? View a past pre-insulated support webinar!



Access-Our-Webinar-Archives



Read More

Eight Custom-Built Variable Springs for a Power Plant

June 3, 2005
Eight Custom-Built Variable Springs For A Power Plant
Eight Custom-Built Variable Springs for a Power Plant

All of the spring components are made of A4150H and carbon steel. Per customer’s request, a two coat epoxy paint was applied to the springs. The Type-A variable spring assemblies measure 22″ x 79″ with an installed load of 45,000 lb., operating load of 56,000 lb., and a downward travel of 5″. The Type-C assemblies measure 22″ x 89″ with an installation load of 38,000 lb., operating load of 47,000 lb., and a downward travel of 5 1/2″. Each spring coil was tested to insure the wire diameter, coil height, and spring rates.

Do you see a need for variable springs in your piping system? Get a price quote today!


Request-A-Quote


Read More
Top