126″ Long Sway Braces for a Power Plant

April 22, 2009
126&Quot; Long Sway Braces For A Power Plant
126" Long Sway Braces for a Power Plant
126&Quot; Long Sway Braces For A Power Plant
Sway Braces

These PT&P sway braces are fabricated from carbon steel and measure 126″ from pin to pin. They use an integral piston assembly with guide to eliminate any buckling and/or misalignment during extension and compression. The sway braces are designed for 10 1/2″ of travel and a load of 1,500 lb. A combination of standard spring coils is used to achieve the required spring rate of 150 lb./in.

Prior to shipment, a test was performed using a hydraulic ram. This test simulated actual field conditions and allowed the sway brace to move through the entire travel range in both compression and extension modes.

Want to learn more about sway braces? Watch a shock & vibration control webinar now!

Read More

C-Type Constant with Special Lugs for a Power Plant

April 8, 2009



C-Type Constant With Special Lugs
C-Type Constant with Special Lugs

This PT&P 100 C-Type constant spring support was designed in conjunction with special lugs to fit inside of a trolley. The lugs will provide for movement up and down, as well as extensive horizontal movement. This constant was fabricated entirely from A-36 carbon steel with a hot-dipped galvanize finish. The constant measures 16″ wide x 25″ long x 56″ high. It is designed to carry 16,164 lb. of piping load with a travel of 3 1/2″ downward. The lugs will fit within a trolley by a single pin connection. This configuration will prevent swinging by maintaining the constant in an upright position, which will ensure proper functionality and eliminate any load deviation.

Do you require constants for an upcoming project? Get pricing today!

Read More