PT&P manufactured seventy-two bolt cradle pipe supports for a Sulphuric Acid Plant in Canada. The supports are designed for pipes ranging from 1-1/2″ to 20″ in diameter. They are fabricated from carbon steel and coated with a special protective paint for acid service. Standard bolt cradle supports are offered in 2″ to 24″ diameter pipe sizes; however, PT&P can manufacture any size needed for your application.
Read More
112 custom variable springs designed for a furnace application for an oil refinery in Venezuela. The furnace cans are designed from carbon steel and painted with red oxide primer to prevent corrosion when exposed to high temperatures. The sizes of these figures PTP-6 and PTP-8 range in length from 25″- 39″, with a total travel of 0.1″- 1.821″ and loads varying from 430 – 681 lb. A load test to confirm the spring rate was conducted on each assembly prior to shipment.
Read More
These pipe guides were designed for a recovery boiler in a power plant in Oklahoma. The guides were designed to control lateral pipe movement and maintain the alignment of the piping through its axial and contraction cycles. They were designed to support 6″, 12″ and 18″ pipes and range in length from 70″ – 120″. The assemblies were fabricated from carbon steel with a hot-dipped galvanized finish.
Read More